nspire student software activation reinstall

If I try to send the file, I get a transfer error of no response from remote system.

At this point, System Error pops up above the bar and an exclamation triangle appears in the lower left corner of the screen.

All of the options reboot the calculator and begin the cycle again.

I continued to C2.

When I pressed the reset button, the system error came up.

Applying it wont work and may even brick your calculator permanently.

Applying the following instructions on a TI-Nspire CX with hardware revision J or above is going to brick it beyond repair by any software.

That is much (more than a year) newer than the I hardware revision.

Honestly, what more can we do One thing is sure: pulling tutorials and tools which have worked for hundreds of persons isnt going to happen.

Its the same troubleshooting procedure as fixing calculators semi-bricked by the defective official OS 3.0.1.1753 upgrade: repairing a calculator with a missing damaged wrong boot2.

Adapters are standalone, they are based on a variety of USB - RS232 TTL adapter chips, such as, but not limited to, the FTDI 232 family, some members of the CP210x (e.g.

PL2303.

But others here would have more definitive answers about the Arduino.

I have a PL2303-based adapter in addition to the FTDI-232-R-based adapter, but the PL2303-based adapter has a DB9 serial interface, which has higher voltage and different protocol than RS232 TTL, so Ive never used it to communicate with the Nspire.

However, when I replace the battery into the calculator as directed on page 9, I do not get the message or text to appear in HyperTerminal.

I have made sure that the connections are good and the communication values are set properly.

The battery may be dead because there are now two icons: system error and one with a battery.

The boot1 (and boot2, OS, but you dont have that just yet) print output on the RS232 TTL port.

However, it was copied from TI Planet and had none of the warnings about hardware revision.

Mine is P-1213M. I have an RS232 cable, and connected it to the right pins on my calculator.

However, when I plug in the battery when Hyper Terminal is open, I get a bunch of gibberish instead of the expected message.

HyperTerminal, which is used in the above tutorial, only allows for a 30 day trial.

I occasionally get a good connection with the pins on the TI-Nspire.

At this point, I am supposed to send the boot2.img to the calculator via Xmodem.

Has the TI software changed where we cannot send the boot 2 image to the TI-Nspire CX.

Nspire Student Software Activation Reinstall